how to bend wood planks
Using an electric plank bender to quickly shape your planks without soaking the wood, soaking causing the wood to swell and you would have to wait for it to shrink back.. The warped wood should be covered with a wet paper towel on the concave side. clamp the wood tightly and leave it for about a week while observing the results closely. if the bend is still there, increase the pressure on the curved area. these are not complete instructions, but rather general summaries of the processes, which are readily found. Plane your lumber into thin strips. once glued back together, these strips will be much more flexible than the original lumber. you can use any type of wood, but cross-grained wood and wood with knots are likely to break. plane it into strips according to how far you plan to bend it: for a curve with a 2 to 4 inch radius (5–10 cm), plane the wood into 3/32" (2.4 mm) strips..
how to bend wood planks
Cut a u shape from the scrap piece of wood. this will act as a jig for bending the work piece, so the u must be as deep as you want the curve in the work piece to be. save the piece that is cut out. to cover the cut side of the work piece, glue a piece of veneer over it.. Curved hardwood nosing on a countertop can really make your project stand out. here's how to make a 3/4-in. laminated hardwood nosing that bends perfectly around round countertop corners. there are several ways to tackle this tough chore, but bending wood and laminating several thin strips to create.
